Fujitsu

Fujitsu S26361-K1229-V170 Computer Monitor Monitor & Accessory

SCALEOVIEW D19-1

Size of the display for this product, measured diagonally, usually in inches.

The number of distinct pixels in each dimension that can be displayed. It is usually quoted as width × height, with the units in pixels: for example, "1024 × 768" means the width is 1024 pixels and the height is 768 pixels. The higher the number of pixels, the sharper the image.

A screen of a laptop, smartphone, etc., that responds to touch so you can control the interface using your fingers.

Display brightness, measured by its Luminance, presented as a figure in candela per square meter (cd/m2). Typical brightness ratings for monitors range from 250 to 350 cd/m2 with a target value of between 80 to 120 cd/m2 being suitable for most displays in a normal viewing environment.

The response time is the time difference between the moment that a source (for example a video card) sends a signal and that equipment (for example a monitor) receives or display the signal. (Used abbreviations: R/F = Rise and Fall.)

The difference in light intensity between the brightest white and the darkest black.

Maximum horizontal angle at which a display can be viewed with acceptable visual performance.

Maximum vertical angle at which a display can be viewed with acceptable visual performance.

This is the parameter of a picture tube, which specifies the shortest distance between two dots of the same colour. The principle is: the smaller the dot pitch, the better sharpness of image.

The viewable size is often somewhat smaller than the actual size of a monitor, because there is a border around the image.

The colour e.g. red, blue, green, black, white.

Number of VGA (D-Sub) ports (connecting interfaces) in the device. The VGA (D-Sub) connector is a 15 pin connector between a computer and a monitor. It was first introduced in 1987 by IBM.

This is the amount of DVI-I interfaces. Digital Visual Interface (DVI) is a video display interface developed by the Digital Display Working Group (DDWG). The digital interface is used to connect a video source to a display device, such as a computer monitor. DVI-D means DVI digital, which means it can only support digital, but not analog.

The product can be used wih VESA mounting interfaces.

Holes on the edge of devices through which a cable lock can be passed, so the device can be locked to a desk etc.

Indicates whether this product supports is "plug and play". Plug and play is  hardware or software that, after being installed ("plugged in"), can immediately be used ("played with"), as opposed to hardware or software which requires configuration.

Amount of power consumed by this model, often expressed in watts (W). Typical values that manufacturers give are power consumption when off, standby/suspended mode, typical use, maximum usage.

The amount of electricity that is consumed when the product is on standby.

Fujitsu SCALEOVIEW Series SCALEOVIEW D19-1. Display diagonal: 48.3 cm (19"), Display resolution: 1280 x 1024 pixels, Response time: 5 ms, Viewing angle, horizontal: 170°, Viewing angle, vertical: 160°. Product colour: Black

Fujitsu SCALEOVIEW Series SCALEOVIEW D19-1, 48.3 cm (19"), 1280 x 1024 pixels, 5 ms, Black

Fujitsu S26361-K1229-V170 Computer Monitor Monitor & Accessory

Reviews

Loading...

Description

Product Features:

Fujitsu SCALEOVIEW Series SCALEOVIEW D19-1 computer monitor 48.3 cm (19") 1280 x 1024 pixels Black

Specification

Display

Design

Ports & interfaces

Ergonomics

Power

Weight & dimensions

Other features

Media